Photo-radiometer for artificial optical radiation assessment

HD2402

Photo-radiometer for artificial optical radiation measurement across lux, UV, UVA, blue and IR bands. It records 96,000 data at 1 s intervals and connects via USB for DeltaLog13 configuration.

Introduction

Workplace exposure assessments need measurements that cover the relevant parts of the optical spectrum without slowing the campaign down. This portable photo-radiometer measures non-coherent artificial optical radiation for evaluations according to European Directive 2006/25/EC and Legislative Decree 81/2008.
 
Six integrated sensors cover illuminance, UV, UVA, blue light, IR and infrared irradiance, including spectral ranges from 220...400 nm, 315...400 nm, 400...700 nm, 700...1300 nm and 400...2800 nm. The integrated LASER pointer helps direct the instrument towards the source under investigation, while the rear LED shows acquisition status.
 
DeltaLog13 software supports the full measurement workflow: configuration, range setting, real-time acquisition, data download, graphical analysis and final report tables. Once configured, the instrument can operate independently from the PC, storing 96,000 data at a fixed 1 second interval for about 26 hours of continuous acquisition.

AOR assessment
Supports non-coherent optical radiation checks under 2006/25/EC and L.D. 81/2008.
Broad spectral view
Six sensors measure UV, UVA, blue, IR, infrared irradiance and illuminance.
Precise targeting
Integrated LASER pointer helps aim the instrument at the light source under test.
Standalone logging
Stores 96,000 data at a fixed 1 second interval for about 26 hours.
Software workflow
DeltaLog13 supports setup, real-time acquisition, download, analysis and reports.

Features

Measurement channels

The instrument uses photodiode sensors with filters for channels 2, 3, 5, 6 and 7, plus a thermopile sensor for channel 9.

Measurement ranges

Four measurement scales are available for all channels except channel 9, which has one measurement scale.

PC connection

The CP24H cable connects the M12 instrument connector to a PC USB port or to the SWD05 power supply unit.

Operating modes

The instrument can run connected to a PC through DeltaLog13 or operate from an external power supply after configuration.

Manual control

A rear push-button starts or stops logging when the instrument is not connected to a PC and also activates the LASER pointer.

Instrument construction

The housing uses aluminum alloy with a rubber protection sleeve and weighs approximately 500 g.